1. INSTALL STARTER ASSEMBLY

(a) Connect the starter wire with the nut. Torque: 9.8 N·m (100 kgf·cm, 87 in·lbf)

(b) Connect the starter assembly connector.

(c) Connect the starter assembly to the cylinder block.

(d) Connect the ground wire with the bolt.

Torque: 17 N·m (173 kgf·cm, 13 ft·lbf)

(e) Install the engine wire protector to the starter with the bolt.

Torque: 9.8 N·m (100 kgf·cm, 87 in·lbf)

(f) Install the starter assembly with the 2 bolts. Torque: 25 N·m (255 kgf·cm, 18 ft·lbf)

2. INSTALL REAR WATER BY-PASS JOINT

(a) Install the 2 new gaskets to the cylinder head. HINT: With the flat-bottom of each new gasket facing downward as shown in the illustration, install the 2 gaskets to the engine rear side.

(b) Install the rear water by-pass joint with the 4 nuts. Torque: 18 N·m (184 kgf·cm, 13 ft·lbf)

3. INSTALL AIR TUBE

(a) Install a new gasket to the air tube.

(b) Install the air tube with the 3 bolts.

Torque: 10 N·m (102 kgf·cm, 7 ft·lbf)

Torque: 16 N·m (163 kgf·cm, 12 ft·lbf)

(c) Install the No. 2 air hose with the clip.

4. INSTALL AIR PUMP ASSEMBLY (for Bank 1)

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE: